Adds an opaque color stop to a gradient pattern. The offset
specifies the location along the gradient's control vector.
For example, a LinearGradient's control vector is from
(x0,y0) to (x1,y1) while a RadialGradient's control vector is
from any point on the start circle to the corresponding point
on the end circle.
The color is specified in the same way as in context.setSourceRGB().
If two (or more) stops are specified with identical offset
values, they will be sorted according to the order in which the
stops are added, (stops added earlier will compare less than
stops added later). This can be useful for reliably making sharp
color transitions instead of the typical blend.
Note: If the pattern is not a gradient pattern, (eg. a linear
or radial pattern), then the pattern will be put into an error
status with a status of CAIRO_STATUS_PATTERN_TYPE_MISMATCH.
Adds an opaque color stop to a gradient pattern. The offset specifies the location along the gradient's control vector. For example, a LinearGradient's control vector is from (x0,y0) to (x1,y1) while a RadialGradient's control vector is from any point on the start circle to the corresponding point on the end circle.
The color is specified in the same way as in context.setSourceRGB().
If two (or more) stops are specified with identical offset values, they will be sorted according to the order in which the stops are added, (stops added earlier will compare less than stops added later). This can be useful for reliably making sharp color transitions instead of the typical blend.